ADAPTER CUFF

Layer 0@0,25x.png
IMG_3677@0,25x.png
IMG_3682@0,25x.jpg
cuffs3.jpg
cuffs4.jpg
Layer 0@0,25x.png
IMG_3677@0,25x.png
IMG_3682@0,25x.jpg
cuffs3.jpg
cuffs4.jpg
sale

ADAPTER CUFF

9.00 11.00

Required to use Lightspeed blade

Color:
Quantity:
Add To Cart
 

The Lightspeed adapter cuff allows your 3/4" Lightspeed blade to fit into any 1" ID hilt. It is made from polycarbonate and is reusable from blade to blade.

USE INSTRUCTIONS

Fit your blade fully into the adapter cuff, then insert it into your hilt. Fasten your set screw about 90 degrees from where the slit is. Tie it TIGHT. This will give you the most secure fit. Thumbscrews are not recommended.

Fit your blade fully into the adapter cuff, then insert it into your hilt. Fasten your set screw about 90 degrees from where the slit is. Tie it TIGHT. This will give you the most secure fit. Thumbscrews are not recommended.

PURCHASING INSTRUCTIONS

During checkout, if not doing a pickup, select the shipping option that represents the largest item in your cart. So if you are ordering any blades, then select the "USPS - Blade" shipping option. If you are not ordering any blades, then select the "USPS - Small item" shipping option.